Error Messages - PerkinElmer LabChip GX User Manual

Error Messages

Before a run is started and while an assay is running, the
instrument firmware and software checks for errors (e.g.,
disconnected devices, bad parameters, bad data, etc.). If an error is
detected, an error or warning message displays in the
Depending on the error, the run may continue or be aborted. The
error or warning message describes the problem and either
contains information on how to resolve the problem or directs you to
call PerkinElmer Technical Support (see
For specific information about an error or warning message, click
one of the links below.
General Errors
•
•
•
•
•
•
Chip Warnings
•
•
LabChip GX Warnings
•
•
•
V4.2
Device <Name> is Disconnected
Plate Carrier Motion Blocked
Home Timeout
Move Timeout
Pressure Leak Detected
Focus Failed
HV Check Failed
Current Leakage Check Failed
HV Check Failed
Current Leakage Check Failed
Chip Temperature Warning
LabChip GX User Manual
Troubleshooting and Diagnostics 285
page 3).
Run Status.
PerkinElmer