Diagnostics; Running The Diagnostics Tests - PerkinElmer LabChip GX User Manual

Diagnostics

The LabChip GX software contains a set of diagnostic tests to verify
proper operation of the LabChip GX or GX II instrument. These
tests are not dependent on assay chemistry. All tests must pass to
ensure the instrument is functioning properly. To open the

Diagnostics

The following procedures are included in this section:
•
•

Running the Diagnostics Tests

To begin running the Diagnostics tests, click the Run Tests button
on the
bottom, prompting you to load the correct chips or plates as
required for each test. Follow the prompts. As each test is
completed, the results display on the right side of the window.
Supplies Required to Run Diagnostics Tests:
•
•
•
•
To order Test Chip A, B, or C, contact PerkinElmer Technical
Support (see
V4.2
Window, select Validation  Diagnostics.
Running the Diagnostics Tests
"Description of Diagnostic Tests" on page 292
System Diagnostics
Test Chip A (PerkinElmer P/N 760453)
Test Chip B (PerkinElmer P/N 760489)
Test Chip C (PerkinElmer P/N 760624)
Test Plate with barcode label
page 3).
LabChip GX User Manual
Troubleshooting and Diagnostics 291
Window. The tests run from top to
System
PerkinElmer