Removing A Manual Baseline; Selecting A Default Ladder - PerkinElmer LabChip GX User Manual

Removing a Manual Baseline

To reset a manual baseline back to the original analyzed baseline:
1
To reset all manual baselines:
1
2

Selecting a Default Ladder

For DNA, gDNA, and RNA assays, a ladder in an assay can be
defined as the default ladder. The default ladder can be used as the
ladder for wells on the plate, can be applied to all of the plates in
the open collection, or can be saved as the default ladder in a new
assay.
To set a specific ladder on a plate as the default ladder for the plate:
1
2
3
4
V4.2
Right-click on one end of the manual baseline and select Reset
to Analyzed Base from the shortcut menu.
Right-click on one end of a manual baseline and select Reset
All Peak Bases.
Click OK in the Reset All Peak Bases window.
With the plate data file open, select Analysis  Analysis
Settings to open the
Peak Find Tab.
Under Well Peak Find Settings, in the Well drop-down list,
select the ladder that will be defined as the default ladder.
Click the Save as Default Ladder button. (The Save as Default
Ladder button only displays when a ladder is selected.)
Click the Apply button to save the default ladder settings. The
Analysis Tab displays the ladder data in the Default Ladder table
and the Markers table (see
LabChip GX User Manual
Assay Analysis Window, and then click the
Figure 30 on page
Data Analysis 77
78).
PerkinElmer