Modifying Analysis Parameters - PerkinElmer LabChip GX User Manual

Modifying Analysis Parameters

Some analysis parameters can be changed in the software to
modify the data evaluation for sample analysis. The following
procedures are included in this section:
•
•
•
•
•
•
•
•
•
•
•
•
•
These settings can be changed after the run is complete or when
reanalyzing a previously saved data file.
V4.2
"Changing the Peak Find Parameters" on page 73
"Adding a Peak" on page 74
"Splitting a Peak" on page 75
"Excluding a Peak" on page 74
"Merging Two Peaks" on page 75
"Adjusting the Peak Baseline" on page 76
"Setting the Baseline for a Range of Peaks" on page 76
"Selecting a Default Ladder" on page 77
"Using the Default Ladder for Alignment" on page 79
"Exporting the Default Ladder in an Assay" on page 79
"Clearing the Default Ladder in a Plate" on page 79
"Changing the Time Window for Analysis" on page 80
Aligning or Unaligning the Marker Peaks
LabChip GX User Manual
Data Analysis 72
PerkinElmer