ABB ACS880 Firmware Manual page 116

116 Parameters
No. Name/Value
133.32 Edge counter 1 func
Bit Function
0 Counter mode
0 = Loop: If warning is enabled by bit 1, it stays active only for 10 seconds
1 = Saturate: If warning is enabled by bit 1, it stays active until reset
1 Warning enable
0 = Disable: No warning is given when the limit is reached
1 = Enable: A warning is given when the limit is reached
2 Count rising edges
0 = Disable: Rising edges are not counted
1 = Enable: Rising edges are counted
3 Count falling edges
0 = Disable: Falling edges are not counted
1 = Enable: Falling edges are counted
4...15 Reserved
0000h...FFFFh
133.33 Edge counter 1
source
False
True
RO1
Other [bit]
133.34 Edge counter 1
divider
1...4294967295
133.35 Edge counter 1
warning selection
Edge counter 1
Main contactor
Output relay
Supply unit starts
Power ups
DC-charge
133.40 Edge counter 2
actual
0...4294967295
133.41 Edge counter 2 limit
0...4294967295
Description
Configures signal edge counter 1. This counter is
incremented every time the signal selected by parameter
133.33 Edge counter 1 source
depending on the setting of this parameter). A divisor may
be applied to the count (see
After the limit set by 133.31 Edge counter 1 limit
the warning specified by
selection is given (if enabled by this parameter), and the
counter reset.
The current value of the counter is readable from parameter
133.30 Edge counter 1 actual. Bit 2 of
status indicates that the count has exceeded the limit.
Edge counter 1 configuration word.
Selects the signal to be monitored by signal edge counter 1.
Constant 0.
Constant 1.
Bit 0 of 110.21 RO status
Source selection (see Terms and abbreviations
13).
Divisor for signal edge counter 1. Determines how many
signal edges increment the counter by 1.
Divisor for signal edge counter 1.
Selects the warning message for signal edge counter 1.
Pre-selectable warning message for signal edge counter 1. 2
Pre-selectable warning message for signal edge counter 1. 11
Pre-selectable warning message for signal edge counter 1. 12
Pre-selectable warning message for signal edge counter 1. 13
Pre-selectable warning message for signal edge counter 1. 14
Pre-selectable warning message for signal edge counter 1. 15
Reading of signal edge counter 2. Can be reset from the
Drive composer PC tool, or from the control panel by
keeping Reset depressed for over 3 seconds.
Reading of signal edge counter 2.
Sets the warning limit for signal edge counter 2.
Warning limit for signal edge counter 2.
switches on or off (or either,
133.34 Edge counter 1
is reached,
133.35 Edge counter 1 warning
133.01 Counter
(page 60).
on page
Def/FbEq16
0000b
divider).
1 = 1
False
0
1
2
-
1
1= 1
Edge counter
1
-
1 = 1
0
1 = 1