ABB ACS880 Firmware Manual page 144

144 Parameters
No. Name/Value
196.03 Access level status
000b...111b
196.06 Param restore
Done
Restore defs
Clear all
196.07 Param save
Done
Save
196.08 Control board boot
0...1
196.20 Time
synchronization
source
Internal
DDCS Controller
Fieldbus A or B
Fieldbus A
Fieldbus B
Panel link
Ethernet tool link
Description
Shows which access levels have been activated by pass
codes entered into parameter
Bit Name
0 End user
1 Service
2 Advanced programmer
3...10 Reserved.
11 OEM access level 1
12 OEM access level 2
13 OEM access level 3
14 Parameter lock
15 Reserved.
Active access levels.
Restores the original settings of the control program, ie,
parameter default values.
Note: This parameter cannot be changed while the
converter is running.
Restoring is completed.
All parameter values are restored to default values, except
fieldbus adapter and drive-to-drive link data.
All parameter values are restored to default values,
including fieldbus adapter configuration data. PC tool
communication is interrupted during the restoring. The
DC/DC converter unit CPU is re-booted after the restoring is
completed.
Saves the valid parameter values to permanent memory.
Note: A new parameter value is saved automatically when
changed from the PC tool or panel but not when altered
through a fieldbus adapter connection.
Save completed.
Save in progress.
Changing the value of this parameter to 1 reboots the
control unit. The value reverts to 0 automatically.
1 = Reboot control unit.
st
Defines the 1 priority external source for synchronization
of the unit's time and date.
No external source selected.
External controller.
Fieldbus interface A or B.
Fieldbus interface A.
Fieldbus interface B.
Control panel, or Drive composer PC tool connected to the
control panel.
Drive composer PC tool through an FENA module.
196.02 Pass code.
Def/FbEq16
001b
-
Done
0
8
62
Done
0
1
0
1 = 1
DDCS
Controller
0
1
2
3
4
8
9