ABB ACS880 Firmware Manual page 115

No. Name/Value
Additional cooling
fan
Cabinet fan
DC-capacitor
133.20 On-time 2 actual
0 ... 4294967295 s
133.21 On-time 2 limit
0 ... 4294967295 s
133.22 On-time 2 function
Bit Function
0 Counter mode
0 = Loop: If warning is enabled by bit 1, it stays active only for 10 seconds
1 = Saturate: If warning is enabled by bit 1, it stays active until reset
1 Warning enable
0 = Disable: No warning is given when the limit is reached
1 = Enable: A warning is given when the limit is reached
2...15 Reserved
0000h...FFFFh
133.23 On-time 2 source
False
True
RO1
Other [bit]
133.24 On-time 2 warning
select
On-time 2
Device clean
Additional cool fan
Cabinet fan
DC-capacitor
133.30 Edge counter 1
actual
0...4294967295
133.31 Edge counter 1 limit
0...4294967295
Description
Pre-selectable warning message for on-time timer 1.
Pre-selectable warning message for on-time timer 1.
Pre-selectable warning message for on-time timer 1.
Reading of on-time timer 2. Can be reset from the Drive
composer PC tool, or from the control panel by keeping
Reset depressed for over 3 seconds.
Reading of on-time timer 2.
Sets the warning limit for on-time timer 2.
Warning limit for on-time counter 2.
Configures on-time timer 2. This timer runs whenever the
signal selected by parameter
on.
After the limit set by 133.21 On-time 2 limit
warning specified by 133.24 On-time 2 warning select
given (if enabled by this parameter), and the timer reset.
The current value of the timer is readable from parameter
133.20 On-time 2 actual. Bit 1 of
indicates that the time has exceeded the limit.
On-time timer 2 configuration word.
Selects the signal to be monitored by on-time timer 2.
Constant 0.
Constant 1.
Bit 0 of 110.21 RO status
Source selection (see Terms and abbreviations
13).
Selects the warning message for on-time timer 2.
Pre-selectable warning message for on-time timer 2.
Pre-selectable warning message for on-time timer 2.
Pre-selectable warning message for on-time timer 2.
Pre-selectable warning message for on-time timer 2.
Pre-selectable warning message for on-time timer 2.
Reading of signal edge counter 1. Can be reset from the
Drive composer PC tool, or from the control panel by
keeping Reset depressed for over 3 seconds.
Reading of signal edge counter 1.
Sets the warning limit for signal edge counter 1.
Warning limit for signal edge counter 1.
133.23 On-time 2 source
is reached, the
133.01 Counter status
(page 60).
on page
Parameters 115
Def/FbEq16
7
8
9
-
1 = 1 s
0 s
1 = 1 s
00b
is
is
1 = 1
False
0
1
2
-
On-time 2
1
6
7
8
9
-
1 = 1
0
1 = 1