ABB ACS880 Firmware Manual page 77

No. Name/Value
114.28 AI1 force data
-22.000...
22.000 mA or V
114.29 AI1 HW switch pos
V
mA
114.30 AI1 unit selection
V
mA
114.31 RO status
0000h...FFFFh
114.31 AI1 filter gain
No filtering
125 us
250 us
500 us
1 ms
2 ms
4 ms
7.9375 ms
Description
(Visible when 114.01 Module 1 type
Forced value that can be used instead of the true reading of
the input. See parameter
Forced value of analog input AI1.
(Visible when 114.01 Module 1 type
Shows the position of the hardware current/voltage selector
on the I/O extension module.
Note: The setting of the current/voltage selector must
match the unit selection made in parameter
selection. I/O module reboot either by cycling the power or
through parameter 196.08 Control board boot
validate any changes in the jumper settings.
Volts.
Milliamperes.
(Visible when 114.01 Module 1 type
Selects the unit for readings and settings related to analog
input AI1.
Note: This setting must match the corresponding hardware
setting on the I/O extension module (see the manual of the
I/O extension module). The hardware setting is shown by
parameter 114.29 AI1 HW switch
either by cycling the power or through parameter
Control board boot is required to validate any changes in
the jumper settings.
Volts.
Milliamperes.
(Visible when 114.01 Module 1 type
Status of relay outputs on the I/O extension module.
Example: 00000001b = RO1 is energized, RO2 is de-
energized.
Status of relay outputs.
(Visible when 114.01 Module 1 type
Selects a hardware filtering time for AI1.
See also parameter 114.32 AI1 filter
No filtering.
125 microseconds.
250 microseconds.
500 microseconds.
1 millisecond.
2 milliseconds.
4 milliseconds.
7.9375 milliseconds.
= FIO-11 or FAIO-01)
114.22 AI force sel.
= FIO-11 or FAIO-01)
114.30 AI1 unit
is required to
= FIO-11 or FAIO-01)
pos. I/O module reboot
196.08
= FIO-01 or FDIO-01)
= FIO-11 or FAIO-01)
time.
Parameters 77
Def/FbEq16
-
1000 = 1 mA
or V
-
2
10
mA
2
10
-
1 = 1
No filtering
0
1
2
3
4
5
6
7