ABB ACS880 Firmware Manual page 53

No. Name/Value
106.11 Main status word
0000h...FFFFh
106.16 Status word 1
Bit Name
0 Enabled
1 Inhibited
2 Reserved
3 Reserved
4 Reserved
5 Started
6 Reserved
7 Reserved
8 Local control
9 Network control
10 Ext1 active
11 Ext2 active
12 Charging
13...15 Reserved
0000h...FFFFh
Description
Main status word of the DC/DC converter unit.
Reflects the status of the DC/DC converter unit irrespective
of control source eg, a fieldbus system, control panel
(keypad), PC tool, standard I/O, application program or
sequence programming, and irrespective of actual control
profile which is used to control the DC/DC converter unit.
This parameter is read-only.
The bit assignments are shown in the table below. For
detailed bit descriptions, see page 196.
Bit Name
0 Ready to switch ON
1 Ready run
2 Ready ref
3 Tripped
4 -
5 -
6 -
7 Warning
8 Operating
9 Remote
10 Ready for load
11 User bit 0
12 User bit 1
13 User bit 2
14 Charging
15 User bit 3
Main status word.
Status word 1 of the DC/DC converter unit.
This parameter is read-only.
Description
1 = Run enable and start enable signals are present
1 = Start inhibited
1 = DC/DC converter has been started
1 = DC/DC converter is in local control
1 = DC/DC converter is in network control
1 = Control location Ext1 active
1 = Control location Ext2 active
1 = Charging relay is closed
Status word 1.
Parameters 53
Def/FbEq16
-
1 = 1
-
1 = 1