1.3
Connecting to the Ethernet Interface
Connection Procedure
Connect a UTP (Unshielded Twisted-Pair) or STP (Shielded Twisted-Pair) cable that is connected to a
hub or other network device to the Ethernet port on the rear panel of this instrument.
Controller
(PC or work station)
RJ-45 modular jack
Notes about Connections
• To connect the instrument to a PC, be sure to connect through a hub or router. Proper operation is
not guaranteed for a one-to-one connection.
• Use a network cable that supports the data rate of your network.
Note
For details on how to connect the instrument to a network, see section 13.1, "Connecting to a Network" in the
User's Manual, IM WT5000-02EN.
IM WT5000-17EN
Hub or router that supports 1000BASE-T
UTP or STP cable
Ethernet port
WT5000
1
2
3
4
5
6
7
App
Index
1-3