Configuring The Instrument Ethernet Settings - YOKOGAWA WT5000 User Manual

1.4

Configuring the Instrument Ethernet Settings

This section explains the settings listed below. You must configure these settings when controlling the
instrument remotely through an ethernet interface.
• Network connection timeout setting
Utility Settings Overview (Utility)
You can display the remote control setting screen from the utility settings overview screen.
The utility settings overview screen can be opened mainly using the following two methods.
* For information about the utility settings overview screen, see section 1.4 in the User's Manual, IM WT5000-
02EN.
Procedure Using the Setup Menu
1. Tap the Setup icon (
Tap the Utility tab. The utility settings overview screen appears.
2.
Pressing ESC closes the list.
Note
• You can also display the utility settings overview screen by moving the cursor on the Utility tab using the
arrow keys and then pressing SET.
• You can also display the list from the navigation screen that appears immediately after power-on.
Procedure Using the UTILITY Key
Press UTILITY on the front panel. The utility settings overview screen appears.
1.
Pressing ESC closes the list.
1-4
), or press MENU under SETUP.
Navigation screen
Utility tub
Display the list (Setup menu)
IM WT5000-17EN