YOKOGAWA WT5000 User Manual page 12

Remote Control Settings (Remote Control)
1. Use either method below to open the utility settings overview screen.
• Procedure using the Setup menu: See the previous page.
• Procedure using the UTILITY key: See the previous page.
2. Tap the Remote Control button.
The remote control setting screen (Network (VXI-11), GP-IB, USB (USB-TMC)) appears.
3. Tap Time Out. Use the displayed input box to set the timeout value.
Remote Control button
IP address
For the setup procedure, see section 13.2 in
the User's Manual IM WT5000-02EN.
Note
Only use one communication interface: Network, GP-IB, or USB. If you send commands simultaneously from
more than one communication interface, this instrument will not execute the commands properly.
TCP/IP Settings
To use the Ethernet interface, you must specify the following TCP/IP settings.
• IP address
• Subnet mask
• Default gateway
For instructions on how to specify these settings, see section 13.2, "Configuring TCP/IP Settings" in
the User's Manual, IM WT5000-02EN.
IM WT5000-17EN
Set the timeout period
(Infinite, 1 to 3600 sec)
1.4 Configuring the Instrument Ethernet Settings
Set the command type
(see chapter 7).
1
2
3
4
5
6
7
App
Index
1-5