Status Reports - YOKOGAWA WT5000 User Manual

5.16 STATus Group
The commands in this group are used to make settings and queries related to the status report.
There are no setup screens that correspond to the commands in this group. For information about status reports, see
chapter 6.
:STATus?
Function Queries all the settings for the communication
status feature.
Syntax :STATus?
:STATus:CONDition?
Function Queries the contents of the condition register.
:STATus:CONDition?
Syntax
:STATUS:CONDITION? -> 16
Example
Description For information about the condition register, see
chapter 6, "Status Reports."
:STATus:EESE
Function Sets or queries the extended event enable
register.
:STATus:EESE <Register>
Syntax
:STATus:EESE?
<Register> = 0 to 65535
:STATUS:EESE #B0000000000000000
Example
:STATus:EESE?
-> :STATUS:EESE 0
Description For information about the extended event enable
register, see chapter 6, "Status Reports."
:STATus:EESR?
Function Queries the contents of the extended event
register and clears the register.
:STATus:EESR?
Syntax
:STATUS:EESR? -> 0
Example
Description For information about the extended event register,
see chapter 6, "Status Reports."
:STATus:ERRor?
Function Queries the error code and message of the last
error that has occurred (top of the error queue).
:STATus:ERRor?
Syntax
Example :STATUS:ERROR?
-> 113,"Underfined Header"
Description • If no error has occurred, 0, "Noerror" is returned.
• You can use the :STATus:QMESsage
command to specify whether the message is
included.
IM WT5000-17EN
:STATus:FILTer<x>
Function Sets or queries the transition filter.
:STATus:FILTer<x> {RISE|FALL|BOTH|
Syntax
NEVer}
:STATus:FILTer<x>?
<x> = 1 to 16
:STATUS:FILTER2 RISE
Example
:STATus:FILTER2?
-> :STATUS:FILTER2 RISE
Description • Set how each bit in the condition register must
change to trigger the setting of an event.If a
bit is set to RISE, an event is set when the bit
changes from 0 to 1.
• For information about the transition filter, see
chapter 6, "Status Reports."
:STATus:QENable
Function Sets or queries whether messages other than
errors will be stored to the error queue (ON/OFF).
:STATus:QENable {<Boolean>}
Syntax
:STATus:QENable?
:STATUS:QENABLE ON
Example
:STATus:QENABLE?
-> :STATus:QENABLE 1
:STATus:QMESsage
Function Sets or queries whether message information will
be attached to the response to the STATus:
ERRor? query (ON/OFF).
Syntax :STATus:QMESsage {<Boolean>}
:STATus:QMESsage?
:STATUS:QMESSAGE ON
Example
:STATus:QMESSAGE?
-> :STATus:QMESSAGE 1
:STATus:SPOLl?
Function Executes serial polling.
Syntax :STATus:SPOLl?
:STATUS:SPOLL? -> :STATUS:SPOLL 0
Example
1
2
3
4
5
6
7
App
Index
5-85