Configuring The Instrument Usb Settings - YOKOGAWA WT5000 User Manual

2.4

Configuring the Instrument USB Settings

This section explains the settings listed below. You must configure these settings when controlling the
instrument remotely through a USB interface.
• Viewing the serial number that is used in USB TMC communications
Remote Control Settings (Remote Control)
1. Use either method below to open the utility settings overview screen.
• Procedure using the Setup menu: See section 1.4.
• Procedure using the UTILITY key: See section 1.4.
2. Tap the Remote Control button.
The remote control setting screen (Network (VXI-11), GP-IB, USB (USB-TMC)) appears.
Remote Control button
Note
• Only use one communication interface: Network, GP-IB, or USB. If you send commands simultaneously
from more than one communication interface, this instrument will not execute the commands properly.
• Install the YOKOGAWA USB driver on your PC. For information about how to obtain the YOKOGAWA
USB driver, contact your nearest YOKOGAWA dealer. You can also access the YOKOGAWA USB driver
download web page and download the driver.
2-4
https://tmi.yokogawa.com/library/
Set the command type
(see chapter 7).
Check the serial number.
IM WT5000-17EN