Configuring QSFP+ Ports
1. Display the current port mode for the QSFP+ ports.
2. Change the port mode to 40GbE. Select the physical port number.
3. Verify the change.
4. Reset the switch.
160
CN4093 Application Guide for N/OS 8.4
QSFP+ ports support both 10GbE and 40GbE, as shown in Table
Table 15.
QSFP+ Port Numbering
Physical Port Number
Port EXT3
Port EXT7
QSFP+ ports are available only when Upgrade 1 is installed (see "Configuring Port
Modes" on page
158).
The following procedure allows you to change the QSFP+ port mode.
CN 4093# show boot qsfp-port-modes
QSFP ports booted configuration:
Port EXT3, EXT4, EXT5, EXT6 - 10G Mode
Port EXT7, EXT8, EXT9, EXT10 - 10G Mode
QSFP ports saved configuration:
Port EXT3, EXT4, EXT5, EXT6 - 10G Mode
Port EXT7, EXT8, EXT9, EXT10 - 10G Mode
CN 4093(config)# boot qsfp-40Gports ext3
CN 4093# show boot qsfp-port-modes
QSFP ports booted configuration:
Port EXT3, EXT4, EXT5, EXT6 - 10G Mode
Port EXT7, EXT8, EXT9, EXT10 - 10G Mode
QSFP ports saved configuration:
Port EXT3 - 40G Mode
Port EXT7, EXT8, EXT9, EXT10 - 10G Mode
CN 4093(config)# reload
Remove the configured port from QSFP+ mode to reset the ports to 10GbE mode.
CN 4093(config)# no boot qsfp-40Gports ext3
40GbE mode
Port EXT3
Port EXT7
15.
10GbE mode
Ports EXT3‐EXT6
Ports EXT7‐EXT10