Calibrating The Touch Screen - ABB IRC5 with FlexPendant Operating Manual

3 Navigating and handling FlexPendant

3.7.2.7 Calibrating the touch screen

3.7.2.7 Calibrating the touch screen
Recalibration
This section describes how to recalibrate the touch screen. The touch screen is
calibrated on delivery and normally never needs to be recalibrated. Depending on
FlexPendant model, the appearance of the symbols will vary, the function is however
the same.
en0400000974
Calibrating the touch screen
Use this procedure to calibrate the touch screen.
1
2
3
4
5
About the touch calibration function
The touch calibration function waits on each calibration point for a couple of touch
coordinates or that the touch will be released. Then the average of the collected
coordinates will be calculated and the symbol moves to the next position.
Continues on next page
118
Action
On the ABB menu, tap Control Panel.
Tap Touch Screen.
Tap Recalibrate.
The screen will go blank for a few seconds.
A series of symbols will appear on the screen, one
at a time.
Tap the center of each symbol with a pointed object.
The recalibration is complete.
© Copyright 2018 ABB. All rights reserved.
Information
CAUTION
Do not use a sharp object which
can damage the surface of the
screen.
Operating manual - IRC5 with FlexPendant
3HAC050941-001 Revision: G