MA lighting dot2 User Manual page 585

dot2 User Manual - Glossary
Version 1.5 – 2018-11-29
English
A chaser is an executor mode that runs in a loop, random or bounces in the cue list. Refer to,
View or Cues View.
Cmd (Command):
Instructions you enter into the console.
Command Area:
The right area on the console, below screen 1, including all command keys and encoders.
Command Line:
Located on screen 1, to enter commands into the console. Refer to,
Line.
Control:
Control attributes are, e.g. lamp control, fixture global and scan rate. Preset type number seven. Refer to,
Preset Type View.
Cue:
A look on stage. Refer to,
Cue List:
List with more than one cue, stored on an executor.
D
Dimmer Wheel:
The wheel rightmost on the console. It is always assigned to the dimmer attributes of the selected fixtures.
DMX (digital multiplex, DMX 512):
Communication protocol that connect light consoles with fixture types.
DMX address:
Is the start address which you have on the fixture and in console. Set the DMX address of a fixture in the console,
in the Select DMX Address
DMX channel:
Each attribute of a fixture needs one (8bit) or two (16bit) DMX channels. 512 DMX channels are one DMX
universe. To see all channels of the eight available DMX universes, open the
© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
What is a Cue, How to work with Cues
Window.
How to use the Command Line
or Cue View.
DMX view.
Settings of Executor
or Command
Control
585 of 614