MA lighting dot2 User Manual page 344

dot2 User Manual - Views & Windows
Version 1.5 – 2018-11-29
English
3D
DMX Nodes
To select a tab, tap at the device name, e.g. 3D .
The columns displays the IPv6 address, the hostname and the version of the connected device.
For consoles and DMX Nodes, the type and the XLR connectors are displayed as well.
Important:
Only the hostname of the Node4s are changeable. All other hostnames are readonly.
To change the hostname of a Node4, tap and hold in a cell of the hostname or press the screen encoder. The
virtual keyboard opens.
The assigned hostname is displayed at the front end display of the Node4.
To change the DMX out universe, tap and hold in a cell of the XLR connector or press the screen encoder. The
Calculator opens.
If only 1 universe in total is patched but different XLR outs are necessary, you can assign the same universe to
more than one XLR out.
Important:
To change the universe, a session is NOT required.
To add a device, tap Add . The
Hint:
To add a device, it is not necessary to select the device column first.
Important:
The connected devices and the hostnames of the Node4´s will be saved in the show file.
To remove a device, select the device in the table, tab Remove . The device is removed from the session.
A device can have four different status:
Light Green:
This is your station.
© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
select station... window opens.
344 of 614