MA lighting dot2 User Manual page 32

Hide thumbs Also See for dot2:

Table of Contents

dot2 User Manual - What are...

Version 1.5 – 2018-11-29

Have a look at this table:

We have stored fixture 1 at 100% and on the Singer position in cue number 1. In cue 2 it's turned off.

Down in cue 6 it's turned back on and it's still used in the singer position - but it's a tracked value (it's not actually

stored in cue 2 through 6).

Now we would like to use the same fixture in cue 3 at the drummer position.

So we turn it to 100% and selects the Drummer position. This is stored in cue 3.

So this is our current scenario:

So the new drummer position is stored in cue 3 and tracked until cue 6 where the console new that we needed the

Singer position.

Also notice that it has not protected the dimmer value in cue 6 - it's now a tracked value from cue 3.

So now we need to store the dimmer at 0% in cue 4 and cue 5. If we just do this with a normal store, then it'll track

into cue 6 and turn off the dimmer.

Take the dimmer to 0% and store (merge) cue 4 and 5 as Cue Only.

Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com

Show Quick Links

Table of Contents