MA lighting dot2 User Manual page 475

dot2 User Manual - Commands
Version 1.5 – 2018-11-29
English
Example 1
Important:
If the DMX tester is on, all parked values and values from the programmer will be blocked by the dmx
test value.
To turn off the DMX tester, refer to example 2 or open the
Let´s assume you will make a DMX test with the DMX address 1.7 and set the DMX value at 100 %.
Press DMX 1 . 7 At 1 0 0 Please
The DMX value is 254 and is displayed with a red background in the
Example 2
Let´s assume you will turn off all DMX tester values by using the DMX command.
Press Off DMX Thru Please
All DMX tester values are off.
Hint:
You can also use the
Example 3
Let´s assume, you will figure out which fixture is patched at DMX address 2.2.
Press DMX 2 . 2 Please
The fixture patched at DMX address 2.2 is selected.
Hint:
If you are looking for a fixture patched at universe 1, just press
necessary for universe 1.
Example 4
Let´s assume you will patch fixture 1 to a the DMX address 2.1.
Press + Label
Fixture 1 is patched at DMX address 2.1.
© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
.
tools window to turn off the DMX tester.
.
(= Assign) Fixture 1 At DMX 2 . 1 Please
tools window.
.
DMX
DMX 2 Please
View.
. The universe is not
.
475 of 614