MA lighting dot2 User Manual page 117

Hide thumbs Also See for dot2:

Table of Contents

dot2 User Manual - Keys

Version 1.5 – 2018-11-29

'Low Prio Merge' is the default option. It means Low priority merge. It will only clone the values from fixture 1

when there's a values and where fixture 5 doesn't have any values already - it doesn't destroy any already

existing programming for fixture 5.

'Merge' will clone all the values from fixture 1 into fixture 5. If Fixture 5 had something programmed where

fixture 1 also had something, than the values will be the same as fixture 1. If Fixture 5 have something

programmed that fixture 1 doesn't , then these values will stay.

'Overwrite' will delete all existing values for fixture 5 and clone the values from fixture 1.

Here's some examples:

In your entire show you need fixture 5 to be a copy of fixture 1 and what fixture 5 had isn't needed anymore:

(gives you the Clone command)

In executor 3 you need fixture 5 to be a copy of fixture 1 and what fixture 5 had isn't needed anymore:

(gives you the Clone command)

select Overwrite on screen 1

In executor 3 you need the fixtures in group 2 to be a copy of fixture 1 and since we are not completely sure if the

fixture in group 2 is used already, then we should do a Low Prio Merge :

(gives you the Clone

Fixture 1 At Group 2 If Exec 3 Please

There's a very big range of possibilities when cloning. Please also have a look at the

description.

Table of Contents