MA lighting dot2 User Manual page 274

dot2 User Manual - Views & Windows
Version 1.5 – 2018-11-29
English
Encoder Bar Functions
The default encoder speed is without decimal place.
To change the encoder speed to slow, press the encoder key
To change the encoder speed to ultra slow, press and hold the
encoder speed equals one DMX step.
Figure 18: Effect encoder bar
To use the second function of an encoder, press and hold the
To open the calculator, press the encoder.
For detailed information about the settings, refer to
High Value or Low Value:
To select the high or low value, turn the encoder left or right.
Speed:
To select the speed in BPM (beats per minute), turn the encoder left or right.
Phase:
To select the phase, turn the encoder left or right.
Width or Softness:
To select the width or softness, turn the encoder left or right.
Groups and Blocks
It is possible to enable Groups and Blocks in the effect encoder bar.
Important:
To make Groups and Blocks visible, press
Figure 19: Effect encoder bar – groups and blocks
To enter numbers in the calculator, tap Groups or Blocks.
Groups:
Groups divide selected fixtures into groups that move in the same direction.
© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
. The encoder speed is with decimal place.
key and press the encoder key
key.
What are Effects?.
MA .
. The
274 of 614