Chrysler Sebring 2005 Service Manual page 2118

JR
HVAC HOUSING (Continued)
(9) Using a small screwdriver, depress the recircu-
lation door gear release and remove the recirculation
door gear from the recirculation door shaft (Fig. 12).
Fig. 12 Recirculation Door Release
1 - RECIRCULATION DOOR
2 - SCREWDRIVER
3 - DOOR GEAR RELEASE
NOTE: If the seals on the recirculation-air door is
deformed or damaged, the air door must be
replaced.
(10) Tilt the gear end of the recirculation-air door
up and pull the door out of the air inlet housing.
NOTE: If either foam seal is deformed or damaged,
it must be replaced.
(11) Carefully remove the foam seals from the
heater core and the evaporator tube mounting flange
of the HVAC housing (Fig. 13).
(12) Remove the screws that secure the upper and
lower HVAC housing halves together and separate
the housing halves (Fig. 14).
Fig. 13 HVAC Housing Seals
1 - EVAPORATOR SEAL
2 - A/C EXPANSION VALVE
3 - HVAC HOUSING
4 - HEATER CORE TUBES
5 - HVAC HOUSING STUD
6 - HVAC HOUSING STUD
7 - EXPANSION VALVE BOLT (2)
Fig. 14 HVAC Housing
1 - HVAC HOUSING (TOP HALF)
2 - HEATER CORE
3 - HVAC HOUSING (BOTTOM HALF)
4 - A/C EVAPORATOR
DISTRIBUTION 24 - 45