Chrysler Sebring 2005 Service Manual page 2185

25 - 30 AIR INJECTION
PUMP (Continued)
(9) Disconnect quick connect hose from inlet of the
air pump.
(10) Remove air pump from vehicle (Fig. 6).
Fig. 6 AIR PUMP REMOVED
INSTALLATION
(1) Install air pump to vehicle (Fig. 6).
(2) Connect quick connect hose to inlet of air
pump.
(3) Connect electrical connector (Fig. 5).
(4) Clip electrical connector to mounting bracket
(Fig. 4).
(5) Install 3 mounting nuts (Fig. 2) and tighten.
(6) Lower vehicle.
(7) Connect quick connect hose to the top of air
pump.
(8) Install air inlet tube for the air cleaner box.
(9) Connect negative battery cable.
AIR PUMP FILTER
DESCRIPTION
The filter is part of the Mass Air Flow Sensor
(MAF).
ONE WAY CHECK VALVE
DESCRIPTION
The check valve is located on the exhaust manifold.
OPERATION
The one-way check valve has a one-way diaphragm
which prevents hot exhaust gases from backing up
into the air injection hose and air injection pump.
The check valve will protect the system if the air
injection pump, an air hose ruptures or exhaust sys-
tem pressure becomes abnormally high.
REMOVAL
Location of One Way Check Valve and connector
hose (Fig. 7).
Fig. 7 VALVE AND CONNECTOR HOSE
(1) Squeeze quick connector (Fig. 8) on the con-
necting tube and pull from check valve.
Fig. 8 QUICK CONNECTOR OPERATION
(2) Remove the 2 check valve retaining screws.
(3) Remove check valve from exhaust manifold.
INSTALLATION
(1) Clean the check valve sealing surface on the
exhaust manifold.
JR