Chrysler Sebring 2005 Service Manual page 2107

24 - 34 CONTROLS
RECIRCULATION DOOR ACTUATOR (Continued)
Fig. 44 Recirculation Door Actuator
1 - RECIRCULATION-AIR DOOR ACTUATOR
2 - WIRE CONNECTOR RECEPTACLE
3 - OUTPUT SHAFT
4 - MOUNTING TAB (3)
The recirculation door actuator can be diagnosed
using a DRBIII scan tool. Refer to Body Diagnostic
Procedures for more information.
The recirculation door actuator cannot be adjusted
or repaired and, if faulty or damaged, it must be
replaced.
REMOVAL
WARNING: On vehicles equipped with airbags, dis-
able the airbag system before attempting any steer-
ing wheel, steering column, or instrument panel
component diagnosis or service. Disconnect and
isolate the battery negative (ground) cable, then
wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or
service. This is the only sure way to disable the air-
bag system. Failure to take the proper precautions
could result in accidental airbag deployment and
possible personal injury or death.
(1) Disconnect and isolate the negative battery
cable.
(2) Remove the instrument panel from the vehicle
(Refer to 23 - BODY/INSTRUMENT PANEL/IN-
STRUMENT PANEL ASSEMBLY - REMOVAL).
(3) Disconnect the HVAC wire harness connector
from the recirculation door actuator (Fig. 45).
(4) Remove the three screws that secure the recir-
culation door actuator to the HVAC air inlet housing.
NOTE: When removing the actuator, note the posi-
tion of the actuator shaft and its respective linkage
for installation reference.
(5) Remove the recirculation door actuator from
the HVAC air inlet housing.
Fig. 45 Recirculation Door Actuator
1 - HVAC AIR INLET HOUSING
2 - RECIRCULATION DOOR ACTUATOR
JR