Glass Panel - Chrysler 300M Service Manual

23 - 106 SUNROOF

GLASS PANEL

REMOVAL
(1) Slide sunshade rearward to the open position.
(2) Move the glass panel to the fully closed posi-
tion.
(3) Remove the four attaching screws (Fig. 4).
(4) Lift off glass panel and remove from vehicle.
Fig. 4 SUNROOF GLASS PANEL REMOVAL
1 - ATTACHING SCREW
INSTALLATION
(1) Position glass panel, centered to opening.
(2) Start the four attaching screws.
(3) Tighten screws.
(4) Verify sunroof operation and alignment. Check
fit and adjust as necessary, refer to Sunroof Glass
Panel Adjustment for proper procedures.
ADJUSTMENTS
ADJUSTMENT
(1) Move the sunshade rearward to the open posi-
tion.
(2) Move the sunroof glass panel to the fully closed
position.
(3) Loosen the forward screws on each side enough
to make the front adjustment.
(4) Adjust the front of the sunroof glass panel 1
mm (1/32 inch) below the top surface of the roof
panel.
(5) Tighten the front two screws.
(6) Loosen the rear screws on each side enough to
make the rear adjustment.
(7) Adjust the rear of the sunroof glass panel 1
mm (1/32 inch) above the top surface of the roof
panel.
(8) Tighten the rear two screws.
(9) Check for proper fit. If not OK, repeat glass
panel adjustment.
ADJUSTMENT - SUNROOF GLASS PANEL
TIMING
Sunroof Drive Cable Timing
NOTE: A gage comes with the new motor.
(1) If the glass panel was not in the fully closed
position, when the sunroof drive motor was removed,
the sunroof glass panel needs to be timed, before the
new motor is installed.
(2) Remove sunroof glass panel.
(3) Set gage into the track near the rear of the
opening between the move driver slide and the
bracket (Fig. 5).
(4) Move the driver slide forward or aft to get
proper setting.
(5) Repeat the operation on the other side.
(6) Install sunroof drive motor.
Fig. 5 SUNROOF DRIVE CABLE TIMING
1 - MOVE DRIVER SLIDE FORWARD/AFT
2 - GAGE
LH