Suzuki XL7 2007 Service Manual page 2593

NOTE
Keep the cutting edge of the tool against the
window.
9. Remove the window from the urethane adhesive.
– Leave a base of urethane approximately 2 mm
(0.078 in) on the pinch-weld flange.
– The only suitable lubrication is clear water.
– Use J 24402-A, J 39032, or equivalent to remove
the window.
NOTE
Keep the cutting edge of the knife/tool
against the window. Do this from inside the
vehicle.
10. If necessary, use a long utility knife or similar tool to
remove the bottom corners of the windshield from
the urethane adhesive.
Glass / Windows / Mirrors:
11. With the aid of an assistant (2), remove the
windshield (1) from the vehicle.
Installation Procedure
1. Install the windshield into the opening. Refer to
"Adhesive Installation of Stationary Windows
(Windshield)" "Adhesive Installation of Stationary
Windows (Liftgate)".
2. Install the rearview mirror. Refer to "Rearview Mirror
Replacement".
3. Install the windshield frame appliques. Refer to
"Windshield Frame Applique Replacement: ".
4. Install the interior windshield pillar garnish moldings.
Refer to "Windshield Upper Garnish Molding
Replacement: ".
5. Install the air inlet grille. Refer to "Air Inlet Grille
Panel Replacement: ".
6. Install the windshield wipers arms and blades. Refer
to "Wiper Arm Replacement: ".
7. Remove the double layer of masking tape around
the perimeter of the painted surfaces and the interior
trim.
8. Close the hood.
Windshield Glass Cleaning
Clean the windshield with windshield cleaner, GM P/N
89021822 (Canadian P/N 992727) or equivalent. The
cleaner should not harm the paint finish or scratch the
glass. The glass is clean when the water no longer
beads, but sheets across the entire glass surface.
9E-45