Rear Side Door Window Regulator Motor Replacement - Suzuki XL7 2007 Service Manual

9E-68 Glass / Windows / Mirrors:
Installation Procedure
1. Install the window regulator module into the door.
2. Connect the door harness at the door jamb.
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
3. Install the 3 latch bolts to the door shut face.
Tightening torque
Tighten the bolts to 10 N⋅m (89 lb in).
4. Install the 4 module bolts.
Tightening torque
Tighten the bolts to 8 N⋅m (71 lb in).
5. Connect the electrical connector rosebuds.
6. Install the rear door lower speaker. Refer to "Radio
Rear Side Door Speaker Replacement: " in
Entertainment.
7. Install the rear door window run channel assembly.
Refer to "Rear Side Door Window Channel
Replacement: ".
8. Install the rear door outside handle. Refer to "Rear
Side Door Outside Handle Replacement: ".
Rear Side Door Window Regulator Motor
Replacement
Removal Procedure
1. Remove the rear door trim panel. Refer to "Rear
Side Door Trim Panel Replacement: ".
2. Remove the water deflector. Refer to "Rear Side
Door Water Deflector Replacement: ".
3. Disconnect the electrical connector from the rear
door window regulator motor.
4. Remove the rear door window regulator motor to
regulator screws.
5. Remove the rear door window regulator motor
assembly.