Front Side Door Window Regulator Motor Replacement; Rear Side Door Window Regulator Replacement - Suzuki XL7 2007 Service Manual

Front Side Door Window Regulator Motor
Replacement
Removal Procedure
1. Remove the front door trim panel. Refer to "Front
Side Door Trim Panel Replacement: ".
2. Remove the water deflector. Refer to "Front Side
Door Water Deflector Replacement: ".
3. Disconnect the electrical connector from the front
door window regulator motor.
4. Remove the window from the regulator.
a. Raise the window.
b. Tape the window into position.
5. Remove the front door window regulator motor
screws.
Installation Procedure
1. Align the front door window regulator motor
assembly to the front door window regulator.
Glass / Windows / Mirrors:
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
2. Install the front door window regulator motor to
regulator screws.
Tightening torque
Tighten the front door window regulator motor to
door screws to 8 N⋅m (71 lb in).
3. Connect the electrical connector to the front door
window regulator motor.
4. Install the water deflector. Refer to "Front Side Door
Water Deflector Replacement: ".
5. Install the front door trim panel. Refer to "Front Side
Door Trim Panel Replacement: ".
Rear Side Door Window Regulator
Replacement
Removal Procedure
1. Remove the rear door outside handle. Refer to "Rear
Side Door Outside Handle Replacement: ".
2. Remove the rear door window run channel
assembly. Refer to "Rear Side Door Window
Channel Replacement: ".
3. Remove the rear door lower speaker. Refer to
"Radio Rear Side Door Speaker Replacement: " in
Entertainment.
4. Disconnect the electrical connector rosebuds.
5. Loosen the 2 rear module bolts.
6. Remove the 4 remaining module bolts.
7. Remove the 3 latch bolts from the door shut face.
8. Disconnect the door harness at the door jamb.
9. Remove the window regulator module from the door.
9E-67