General Programming
Step by Step
90
Restoring Default Settings
You can delete the settings that have been configured
and restore the default settings. Only Country/Group of
Countries settings (Code 65) will be saved as last
configured.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
9 9
Enter the system password (default is 31994).
The system restarts.
HiPath 1120 Alarms
You can assign an alarm to a system sensor. When the
alarm is triggered, the system dials the number stored
as entry 249 in the Speed Dialing phonebook (the name
assigned to this entry can be up to 15 characters long.
For example, it can be the name of an emergency
station).
The system ID is automatically sent and continues to be
sent to the station called until the service requested
returns the "#" digit, acknowledging the alarm "#". This
works as a confirmation that the service has detected
the alarm call sent by the system.
If a Fax/DID module is installed, you can send an alarm
message in addition to the Exchange ID.
When an alarm is triggered, the HiPath 1120 makes a
call using the Speed Dialing entry 249. The slot number
is called and a previously programmed sequence of
digits (in DTMF format) is repeated every 6 seconds
after the connection is established.
The purpose of this sequence of digits is to identify the
alarm source. An alarm center, for example, is able to
identify which PABX is sending the signal. If the receiv-
ing switch does not acknowledge the alarm within a
few minutes, the procedure is repeated at specified
time intervals.