Configure G-Sensor Alarm - HIKVISION DS-MP1803 User Manual

Step 2 Select Positioning Module.
 Access of RS-232: Obtain data from the connected RS-232 device.
 Access of RS-485: Obtain data from the connected RS-485 device.
 Built-in: Obtain data from the satellite positioning module built in the device.
 Intelligent Display Terminal: Obtain data from display terminal.
Step 3 Optionally, check Satellite Timing to synchronize device time with satellite time.
Step 4 Select Speed Unit and input Speed Limit of Alarm. If vehicle speed exceeds the set value,
device will alarm.
Step 5 Set the linkage action for speeding alarm, including Audible Warning and Alarm Output.
Step 6 Select The Superimposed Channel of Position. The device positioning information will be
displayed on the selected channels.
Step 7 Click Save.

5.4 Configure G-Sensor Alarm

Purpose:
G-Sensor detects and records acceleration information in 3-axial (X, Y, Z) directions.
Before you start:
Connect an external sensor to the device for obtaining and providing the acceleration speed in
3-axial directions.
Step 1 Go to Configuration > Vehicle > Basic Settings > G-Sensor.
Step 2 Select G-sensor module as External.
 External: The G-sensor is connected to the device through RS-232/RS-485 interface.
 Built-in: The G-sensor is a built-in module of the device.
Intelligent Analyzer User Manual
Figure 5-3 Position Settings
24