Danfoss VLT AutomationDrive FC 300 Design Manual page 85

Selection
Surroundings
Frame size D1h, D2h , E1, F1, F2, F3 and F4
Frame size D3h, D4h
E2
Vibration test, frame size D, E and F
Max. relative humidity
Aggressive environment (IEC 60068-2-43) H
Test method according to IEC 60068-2-43 H2S (10 days)
Aggressive environment (IEC 721-3-3), coated
Ambient temperature (full rating with default parameter settings)
Ambient temperature with derating
For more information on derating for high ambient temperature, see chapter 4.7 Special Conditions.
Minimum ambient temperature during full-scale operation
Minimum ambient temperature at reduced performance
Temperature during storage/transport
Maximum altitude above sea level
Derating for high altitude, see chapter 4.7 Special Conditions
EMC standards, Emission
EMC standards, Immunity
See chapter 4.7 Special Conditions.
Control Card, USB Serial Communication
USB standard
USB plug
Connection to PC is carried out via a standard host/device USB cable.
The USB connection is galvanically isolated from the supply voltage (PELV) and other high-voltage terminals.
The USB ground connection is not galvanically isolated from protection ground. Use only an isolated laptop as PC connection to
the USB connector on the adjustable frequency drive.
MG34S222
Design Guide
5%–95% (IEC 60 721-3-3); Class 3K3 (non-condensing) during operation
S test
2
EN 61000-4-2, EN 61000-4-3, EN 61000-4-4, EN 61000-4-5, EN 61000-4-6
Danfoss A/S © Rev. 2014-02-10 All rights reserved.
IP21, IP54
Class 3C3
Max. 113 °F [45 °C]
Max. 131 °F [55 °C]
32 °F [0 °C]
14 °F [-10 °C]
-13 to +149/158 °F [-25 to +65/70 °C]
3,300 ft [1,000 m]
EN 61800-3, EN 61000-6-3/4, EN 55011
EN 61800-3, EN 61000-6-1/2,
1.1 (Full speed)
USB type B "device" plug
IP20
IP00
1 g
Class Kd
4 4
83