Danfoss VLT AutomationDrive FC 300 Design Manual page 205
90–1200 kw
Hide thumbs
Also See for VLT AutomationDrive FC 300:
- Programming manual (277 pages) ,
- Design manual (275 pages) ,
- Operating instructions manual (169 pages)
Table of Contents
Advertisement
Electrical Installation
Terminal Locations - Options Cabinet (F3 and F4)
Take the following position of the terminals into consideration when designing the cable access.
1
Figure 7.29 Terminal Locations - Options Cabinet. Connector Plate is 1.65 in [42 mm] below .0 Level.
1
Left Side
2
Front Side
Table 7.21 Legend to Figure 7.29
MG34S222
Design Guide
2
134.6[5.30]
0.0[0.00]
3
Right Side
4
Ground bar
Danfoss A/S © Rev. 2014-02-10 All rights reserved.
3
1031.4[40.61]
939.0[36.97]
4
0.0[1.75]
244.4[1.75]
244.4[9.62]
7
7
203
Advertisement
Table of Contents
Need help?
Do you have a question about the VLT AutomationDrive FC 300 and is the answer not in the manual?
Questions and answers