Grease Replenishment And Exchange For L-Axis Speed Reducer; Grease Replenishment - YASKAWA MOTOMAN-HP20D Maintenance Manual

HP20D
4.3

4.3.1 Grease Replenishment

4 Grease Replenishment and Exchange

4.3 Grease Replenishment and Exchange for L-Axis Speed Reducer

Grease Replenishment and Exchange for L-Axis Speed Reducer
Fig. 4-2: L-Axis Speed Reducer
L-arm
Grease inlet
(Hexagon socket head cap screw M6)
(Refer to Fig. 4-2 "L-Axis Speed Reducer".)
1. Make the L-arm vertical to the ground.
2. Remove the hexagon socket head cap screw from the grease inlet and
the hexagon socket head plug from the grease exhaust port.
If grease is injected with the plug on, grease will leak inside
NOTE
the motor and may cause a damage. Make sure to remove
the plug before grease injection.
3. Install the grease zerk A-MT6 x 1 to the grease inlet.
(The grease zerk is delivered with the manipulator.)
4. Inject grease through the grease inlet using a grease gun.
– Grease type:
– Amount of grease:
– Air supply pressure of grease pump:
– Grease injection rate:
5. Move the L-axis for a few minutes to discharge excess grease.
6. Remove the grease zerk from the grease inlet and reinstall the screw.
Apply ThreeBond 1206C to the thread part of the screw, and tighten
the screw with a tightening torque of 5 N•m (0.51 kgf•m).
7. Wipe the discharged grease with a cloth, and reinstall the plug on the
grease exhaust port. Apply ThreeBond 1206C to the thread part of the
plug, and tighten the plug with a tightening torque of 5 N•m
(0.51 kgf•m).
4-4
Grease exhaust port
(Hexagon socket head plug PT1/8)
VIGO Grease No.0
30 cc
(60 cc for 1st supply)
0.3 MPa or less
8 g/s or less
HW1480357
159281-1CD
L-axis speed reducer
30 of 96