Turn On The Air Assist Function; Polish - GCC Technologies LaserPro Spirit Series User Manual

LaserPro Application Lab provides a few reminders that may require your attention during the 3D engraving in
order to improve the result of the engraving.

Turn on the Air Assist function

When the engraving is done along with Air Assist, the depth of the engraving would be deeper. Set Air assist inside
the driver by checking the box.

Polish

Dust will accumulate during the engraving when acrylic is engraved. The acrylic can be polished after the
engraving. After the processing, don't remove the engraved object. Use the Control Panel to lower the platform (for
about 7~8 mm) and then engrave once again to achieve the better finish.
After engraving the wooden objects, please use a toothbrush with some clean water to remove the dust on top of
the object.
150 232001290G(13)