Closing The Smartlid; Cleaning The Work Table And Motion System - GCC Technologies LaserPro Spirit Series User Manual

Anytime you have the SmartLID open, always make sure you have properly engaged the
SmartLID manual locks on both sides of the metal support rails. Failure to do so may
pose a serious risk if the SmartLID slams down.

Closing the SmartLID:

To properly close the SmartLID after you have finished accessing the work table or motion
system, please follow these steps:
1) Disengage both of the sliding locks found on each side of the metal support rails by sliding
them away from you and into the unlock position.
2) Push the SmartLID away from you and move to the maximum position to disengage the latch
(indicated by a small click) and gently close the SmartLID.

8.2.2 Cleaning the Work Table and Motion System

Clean the working table and the motion system on a frequent basis through the following steps:
1) Turn the power off and unplug the Spirit before cleaning.
2) Use a vacuum cleaner with a flexible nozzle to remove dust and debris from the work table
and motion system.
3) Apply small amounts of all-purpose cleaner, alcohol, or acetone to a paper or cotton towel to
clean the working table.
4) Apply a soap solution, all-purpose cleaner, or alcohol to a paper or cotton towel to wipe
down the rails of the motion system.
5) Wait for all cleaning residue to dry completely before plugging in and operating the Spirit
Series.
• Never pour or spray alcohol or acetone directly to the work table.
• Oil, alcohol and acetone can cause fires or smoke build-up if improperly used.
T ip
Please clean the AutoFocus pin each time after completing the engraved job
to make sure the AutoFocus pin is free to move.
W A RNING
C A UTION
181
SmartLID Sliding Lock
232001290G(13)