Carriage / Work Table Adjustment Page - GCC Technologies LaserPro Spirit Series User Manual

Carriage / Work Table Adjustment Page

The Carriage / Work Table Adjustment Page allow you to manually increase and decrease the
height of the work table (Z-axis). In addition, you can manually adjust the Y-axis and X-axis of
the lens carriage.
Relevant Buttons
F1 (Back)
F3 (Down)
F4 (Up)
/ / / Directional
/ Directional
Start / Stop
Auto Focus
/ Manual Focus Buttons
Carriage / Work Table Adjustment Page
Back to previous page
Manually decrease the height of the work table (Z-axis)
Manually increase the height of the work table (Z-axis)
Manually adjust the Y-axis position of the lens carriage
Manually adjust the X-axis position of the lens carriage
Start / Stop the current job
Initiate the auto focus function
Manually adjust the height of the work table (Z-axis)
75
Navigating to this page:
Main Work Page
press,
or F3
Carriage / Work Table
Adjustment Page
Function
232001290G(13)
,