Advanced Option- Smartguard Page; Smartguard Enable / Disable; Sensitivity; Stow Carriage - GCC Technologies LaserPro Spirit Series User Manual

Advanced Option- SmartGUARD Page

After optional SmartGUARD hardware installation, please enter the function menu on the control
panel to enable the SmartGUARD fire alarm. Note SmartGUARD fire alarm system is not a fire
extinguisher, but an fire detecting and alarm system.

SmartGUARD Enable / Disable:

Press directional key (Left or Right) to enable the SmartGUARD device or disable it.

Sensitivity

Press directional key (left or right) to set the sensitivity of SmartGUARD. There are five sensitivity
settings (1, 3, 5, 7, 9 seconds) that can be selected. Sensitivity defines the delay time from when a
fire is detected until the fire alarm alerts user, and automatically stop laser firing. For example, if
the sensor delay switch is set to the 3-second position, the SmartGUARD will start an alarm and
automatically stop laser firing after detecting a fire for 3 seconds.

Stow Carriage

This function will decide if the lens carriage stay in the last position (set to <NO>) or move to the
opposite direction (up or down) when fire alarm is initiated. The default is <YES>, the lens carriage
will move to opposite direction when a fire detected.
Relevant Buttons
F1 (Back)
F4 (Save)
/ Directional
/ Directional
Start / Stop
Auto Focus
/ Manual Focus Buttons
SmartGUARD Setting Page
Back to previous page
Save your current settings
Scroll through the menu selections
Adjust the value for that selection
Back to Main Work Page
Initiate the auto focus function
Manually adjust the height of the work table (Z-axis)
104
Navigating to this page:
Main Work Page
press F4
Functions Page
Select< Adv a nc e d
O ptions >from the menu
Advanced Option Page
Select<S m a rt GU A RD>
from the menu
SmartGUARD Page
Function
232001290G(13)