Machine Setting- Vector Mode Page; Vector Mode Page - GCC Technologies LaserPro Spirit Series User Manual

Machine Setting- Vector Mode Page

The Accel. (Acceleration) function modifies the acceleration and deceleration of the X and Y rails
to adjust and balance vector mode's quality and speed settings based on your specific job.
<Speedy> mode offers the highest output speed while sacrificing certain degree of quality.
Whereas <Quality> mode offers the highest quality, sacrificing output speed. Keep in mind that
speed and quality are usually a trade-off.
Select Smoothing function to <YES>, the laser machine will smooth out the curve path, result in
smooth edge, higher speed, while less precise in scale factor, whereas setting Smoothing to <NO>,
the curve will move in more precision scale, less smooth path, and slower speed.
• Acceleration Modes: Quality, Production, Speedy
[Slower speed/ higher quality
• Smoothing: YES/ NO (default: YES)
T ip
Relevant Buttons
F1 (Back)
F4 (Save)
/ Directional
/ Directional
Start / Stop
Auto Focus
/ Manual Focus Buttons
Enable Smoothing will be most evident when processing small, fine, intricate
designs which request to run in high speed. We recommend you leave
Smoothing to <YES> when cutting such designs. Disable the Smoothing when
precise output scale is required.

Vector Mode Page

Faster speed/ lower quality]
Back to previous page
Save your current settings
Cycle Set Vector Mode between QUALITY/ FINE/
COARSE/ SPEEDY VECTOR
Scroll through menu options
Back to Main Work Page
Initiate the auto focus function
Manually adjust the height of the work table (Z-axis)
96
Navigating to this page:
Main Work Page
press F4
Functions Page
Select<Machine
Setting>from the menu
Machine Setting Page
Select<Ve ctor M od e >
from the menu
Vector Mode Page
Function
232001290G(13)