GCC Technologies LaserPro Spirit Series User Manual page 172

Maximum Length
Maximum Loading Weight
Minimum Diameter
Maximum Diameter
INST ALLATION for Rotary Attachment and Rotary Chuck:
1) Turn off the power of the engraver before installing the Rotary option (Rotary attachment and
Rotary chuck.)
2) Set the rotary option onto the engraving table so that the bottom mounting screws correspond
to the positional holes on the engraving table. In addition, the top end of the rotary option must
be leveled against the engraving table with the rotary's positional indicator (center point of the
top of the rotary) aligned to the center position on the engraver's Y (vertical) axis.
3) With the rotary properly positioned, tighten the mounting screws to secure the rotary.
4) Open the front panel of the Spirit and connect the rotary cable to the rotary port located
inside the Spirit's front panel (shown in the picture below)
5) Close the front panel.
6) The rotary is now properly installed. Power on the laser system and the rotary option will be
automatically detected and the engraving table will automatically move to its lowest position.
The selection screen will be shown on control panel automatically.
7) Despite the dummy-proof installation design, please ensure that the device is installed
correctly before turning on the machine.
8) Please select your device type "Attachment" or "Chuck" then press F4 on control panel to
save.
Work Piece Limitations
410 mm (16.14 inches)
4 kg (8.8 lbs.)
0.5 mm (0.02 inches)
120 mm (4.7 inches)
168 232001290G(13)