Air Flow Regulator:
Turn Clockwise
to increase
airflow
Turn Counter-
Clockwise to
decrease
8)
Congratulations, you have finished setting up the air compressor. Make sure you have the proper
SmartAIR nozzle installed (depending on your application), before you turn on and utilize the air
compressor.
OPERATION:
Switch on the air compressor unit and make sure that the airflow regulator on the air assist value is opened
(turn clockwise to increase the airflow, counter-clockwise to decrease the airflow). The air nozzle under the
laser head should emit a steady flow of air.
With the SmartAIR nozzle and air compressor properly installed and operating, all configurations and
settings relating to air-assist functions are controlled through the LaserPro Spirit GLS print driver and
hardware control panel. Please refer to the LaserPro Spirit GLS PEN page on print driver section of
this manual for details on how to enable and configure air-assist functionality.
159
Air Tube Fastener
Air Tube Connector
232001290G(13)