Stamp Mode; Raster & Stamp Mode; Dpi (Options Page) - GCC Technologies LaserPro Spirit Series User Manual

Stamp Mode:

Select this mode when you would like to engrave stamps. The stamp mode is one of the more
dynamic functions of the LaserPro Spirit Series by applying 200 power levels to create different
steps. Due to the unique engraving nature when engraving a stamp, the stamp production
requires different operational steps than most engraving or cutting operations.
Noted Stamp mode is only suitable for CO2 laser system (Spirit, Spirit LS, Spirit GLS, Spirit GLS
Hybrid CO2 models), not suitable for Spirit GLS Hybrid fiber laser, and CO2/Fiber dual lasers
configurations.
NOTE
Selecting the Stamp mode will enable the Stamp page on the Spirit Series Print Driver,
allowing you to adjust advanced stamp-related settings.
Raster & Stamp Mode:
Select this mode when you would like to engrave image on stamps. The Raster & Stamp mode
combines the 256 level gray scale image processing technology and 200 power level stamp
steps production requirement to create slopes.
Noted Raster & Stamp mode is only suitable for CO2 laser system (Spirit, Spirit LS, Spirit GLS,
Spirit GLS Hybrid CO2 models), not suitable for Spirit GLS Hybrid fiber laser, and CO2/Fiber dual
lasers configurations.
DPI (Options Page) [DEFAULT SETTING: 500]
DPI (dots-per-inch) represents the number of times the laser will fire over a one-inch path. This
setting determines the image resolution and quality when performing raster engraving functions.
Higher DPI settings result in cleaner and deeper engravings, but require more time to complete.
Lower DPI settings result in coarser and shallower engravings, but require less time to complete.
The LaserPro Spirit Series offers 8 DPI options: 125, 250, 300, 380, 500, 600, 760, 1000, and
1500 experiment with different settings to get your desired effect.
Below is a chart for your convenience detailing the Set DPI (your input setting) vs. Actual DPI
(your output results).
Set
125
DPI
Actual
127
DPI
NOTE
Outputting a full-table (25.1" x 18.1") job using 300 or 600 DPI will result in a truncation
error; this is due to the large differences in set DPI vs. actual DPI output for those two
particular DPI settings. Therefore, when processing a 25.1" x 18.1" job using 300 DPI,
we recommend you move to the next higher DPI setting of 380. Similarly, for a 25.1" x
18.1" job using 600 DPI, we recommend you use 760 DPI.
250 300* 380
254 381 381
114
500 600* 760
508 762 762
232001290G(13)
1000 1500
1016 1524