GCC Technologies LaserPro Spirit Series User Manual page 176

If your work piece is small, please apply 4" focal lens for operation to prevent the
lens carriage from colliding with the rotary attachment.
4) Manually move the laser carriage to the proper X/ Y location on the work object where you will
do laser engraving or cutting. Hit the Auto Focus button on control panel and the laser machine will
now properly focus at the location to be laser engraved or cut.
5) Prepare the graphic you would like to work with the Rotary Chuck, print it to GCC laser Print
Driver, and go to "Paper" page of the Print Driver.
6) From the Paper Page, the first thing you must do is to check the Rotary Fixture. The Paper
7) Size options and Rotary Parameter will change to allow for proper input based on your rotary attachment.
a) Under Paper Size, the X value represents the length of your working piece. Enter the length
of your work piece in this field.
b) U U nder Paper Size, the Diameter value represents the diameter of your working piece (at the
position you wish to engrave). Enter the diameter of your work piece in this field. Again remember
the proper diameter value would be the diameter location on your work piece you will be
engraving.
c) Under Rotary Parameter, the Offset value represents distance from machine default origin to
where you would like to start laser job. The default value is zero.
8) Go back to other pages of GCC Laser Print Driver to set up laser parameters like speed, power, dpi etc.
CAUTION
172 232001290G(13)