Operation Of Rotary Attachment And Rotary Chuck - GCC Technologies LaserPro Spirit Series User Manual

OPERATION of Rotary Attachment and Rotary Chuck:

1) Use a ruler to measure the diameter (at the point on the work piece you will be engraving) and
length of the work piece you will be engraving. Make a record of this.
2) Load the work piece onto the rotary attachment
a) First list the lever on the rotary attachment, unlock the adjustable end of the rotary attachment.
Slide the adjustable end to accommodate the length of the work piece. Load the working piece
by centering the open end of the work piece against the rubber wheel and slide the adjustable end
to fit the bottom of work piece firmly. Now simply lower the lever to secure the work piece with the
rotary attachment.
3) Load the work piece onto the rotary chuck
a) Unlock the adjustable rear end of the Rotary Chuck, load the work piece onto the Rotary Chuck
by centering the object to the clamping end and adjustable rear end. Adjust the leveling screws on
the rear end of Rotary Chuck to make sure the work object is centering to the clamping end, thus
work piece is horizontally leveling to the laser carriage in X axis. Slide the adjustable rear end to
accommodate the length of the work piece firmly.
b) To load the object, you can use the enclose tools to widen or tighten the metallic claws. Simply
insert the two metal pins into the holes on the turn-dial and turn it to widen or tighten the claws to
hold the engraving object.
169 232001290G(13)