Smartcenter Page - GCC Technologies LaserPro Spirit Series User Manual

SmartCENTER Page

Under SmartCENTER mode the job will begin after the system positions the carriage to the
center position between two points or four points indicated by the user. The SmartCENTER
mode has to be enabled through the driver.
Enter SmartCENTER page by pressing the <F3> button. You will be prompted to indicate and
store the position points.
pressing enter to save the positions indicated by the red pointer. After all points are set, the
carriage will move to the center of the stored positions and the job will begin.
Relevant Buttons
F1 (Back)
F2 (Reset)
F4 (Save)
Auto Focus
/ Manual Focus Buttons
The positions can be indicated by moving the carriage by hand and
SmartCENTER Page
Back to previous page
Reset all saved positions
Save current lens carriage position
Initiate the auto focus function
Manually adjust the height of the work table (Z-axis)
76
Navigating to this page:
Main Work Page
press F3
SmartCENTER Page
Function
232001290G(13)