Advanced Option- Auto-Feeder Page; Auto-Feeder Page - GCC Technologies LaserPro Spirit Series User Manual

Advanced Option- Auto-Feeder Page

After optional Auto-Feeder hardware installation, please enter the function menu on the control
panel to enable the Auto-Feeder roll to roll system. The winding setting will perform the feeder to
take up the materials in <CW> (Clockwise) or <CCW> (Counterclockwise) which depends you
want to take up the laser cut roll media with printed page toward inside or outside. The <Repeat
No.> will decide the times the laser system to output the same jobs after the feeder wind to the
next work area/ page. Follow the user manual comes along with the Auto-Feeder hardware for
operation details.
• Auto-Feeder: Enable/ Disable
• Winding: CW/ CCW
• Repeat No.: 0-1000 (0 stands for unlimited repeat)
NOTE: Auto-Feeder and AAS Calibration options are only available for those Spirit series machines
with CO2 laser tube configuration.
Relevant Buttons
F1 (Back)
F4 (Save)
/ Directional
/ Directional
Start / Stop
Auto Focus
/ Manual Focus Buttons

Auto-Feeder Page

Back to previous page
Save the settings
Adjust the value for that selection
Scroll through the menu selections
Back to Main Work Page
Initiate the auto focus function
Manually adjust the height of the work table (Z-axis)
105
Navigating to this page:
Main Work Page
press F4
Functions Page
Select< Adv a nc e d
O ptions >from the menu
Advanced Option Page
Select<Auto-Feeder>
from the menu
Auto-Feeder Page
Function
232001290G(13)