Cutting Box And Honeycomb Table; Aluminum Grid Cutting Table; Cutting Box And Material Support Stands - GCC Technologies LaserPro Spirit Series User Manual

NOTE
Experienced users may choose to try other component setups to suit their particular
engraving / cutting techniques or working material. Feel free to explore different ways
to setup the various SmartBOX components to generate results you wish to achieve.
INSTALLATION/ OPERATION (Cutting Box and Honeycomb Table/

Aluminum Grid Cutting Table):

1) Open the front pass-through door and lower the work table to the lowest possible position
through the control panel.
2) Insert the cutting box and attached honeycomb table through the open front pass-through
door onto the work table, with the air extraction opening facing towards the back end of the
Spirit Series. Ensure the rear and left side of the cutting box is aligned to the edges of the left
and right rulers on the work table.
3) Lift the honeycomb table to find the four screw holes at the bottom of the cutting box. With the
included thumbscrews, secure the cutting box to the work table and close the honeycomb
table.
4) [OPTIONAL] If you have an air extraction system option installed, then you will need to attach
the air extraction system's pipe connector to the SmartBOX's air extraction opening from the
Spirit Series rear side. (For detailed instructions to setup the air extraction system, please see
the AIR EXTRACTION UNIT section in section 7.1).
Congratulations, you are now ready to position your thin, flexible materials on top of your
honeycomb table / cutting box and commence your tasks.
INSTALLATION/ OPERATION (Cutting Box and Material Support Stands):
1) In order to use the cutting box along with the material support stands, you must first remove
the honeycomb table from the cutting box. Before you position the cutting box in the Spirit
Series, first loosen the screws that attach the hinges of the honeycomb table to the cutting
box.
2) Remove the honeycomb table. Please keep in mind the honeycomb table surface is fragile;
therefore, it is suggested to keep it in a safe place.
3) Open the front pass-through door and lower the Spirit's work table to the lowest possible
position through the Spirit Series control panel.
4) Insert the cutting box through the open front pass-through door and place it onto the work
table, with the air extraction opening facing towards the back end of the Spirit Series. Ensure
the rear and lefthand side of the cutting box is aligned to the edges of the left and right rulers
on the work table.
5) Find the four screw holes at the bottom of the cutting box. With the included thumbscrews,
secure the cutting box to the work table.
6) On the front right hand side of the cutting table, there will be a metal guard, which must be
swiveled so that it is perpendicular to the front side of the cutting table (as shown in the picture
below). This allows the Spirit Series to properly account for the extra height the cutting table
which adds to the cutting table.
164 232001290G(13)