MiiNePort E2/E3
DNS
Command code: ND
Command parameters: The index (1 or 2) of DNS server.
Reply parameters: MiiNePort's DNS address.
?GND1
!GND0192.168.1.2
PHY Speed
Command code: NS
Command parameters: N/A
Reply parameters: MiiNePort's PHY speed as follows:
0
PHY auto negotiation is enabled.
10
PHY speed is forced to 10Mbps with half duplex
11
PHY speed is forced to 10Mbps with full duplex
100
PHY speed is forced to 100Mbps with half duplex
101
PHY speed is forced to 100Mbps with full duplex
?GNS
!GNS00
Enable/Disable SNMP
Command code: MS
Command parameters: N/A
Reply parameters: 1 (Enable) or 0 (Disable) MiiNePort's SNMP agent.
?GMS
!GMS01
Community String
Command code: MU
Command parameters: N/A
Reply parameters: MiiNePort's SNMP Community string.
?GMU
!GMU0public
Contact Name
Command code: MN
Command parameters: N/A
Reply parameters: MiiNePort's SNMP Contact Name.
?GMN
!GMN0s_name
Introduction to SCM (Serial Command Mode) Command Set
System requests DNS server 1 address for this MiiNePort.
MiiNePort reports DNS server 1 address as '192.168.1.2'.
System requests PHY speed setting for this MiiNePort.
MiiNePort reports PHY speed determined by PHY auto negotiation function.
System requests Enable/Disable SNMP agent for this MiiNePort.
MiiNePort reports SNMP agent as 'Enable'.
System requests SNMP community string for this MiiNePort.
MiiNePort reports SNMP community string as 'public'.
System requests SNMP contact name for this MiiNePort.
MiiNePort reports SNMP contact name as 's_name'.
A-5