MiiNePort E2/E3
Location
Command code: ML
Command parameters: MiiNePort's SNMP location.
Reply parameters: N/A
?SMLlocation
!SML0
Enable/Disable Accessible IP List
Command code: AS
Command parameters: 1 (Enable) or 0 (Disable) MiiNePort's accessible IP list.
Reply parameters: N/A
?SAS1
!SAS0
Accessible IP List
Command code: AI
Command parameters: format is "index;mode;IP;Netmask", where index ranges from 1 to 16, mode is 1 if
activated and 0 if not activated.
Reply parameters: N/A
?SAI1;1;192.168.1.2;255.255.2
55.0
!SAI0
Auto IP Report
Command code: NR
Command parameters: Auto IP report destination and report period.
Reply parameters: N/A
?SNR192.168.1.123:4000;50
!SNR0
Port alias
Command code: SA
Command parameters: Port index and port alias, separated by a semicolon (;).
Reply parameters: N/A
?SSA1;port 1
!SSA0
Introduction to SCM (Serial Command Mode) Command Set
System sets SNMP contact name as 'location'.
MiiNePort reports command executed successfully.
System sets accessible IP list as 'Enable'.
MiiNePort reports command executed successfully.
System sets accessible IP 1 as 'active', IP address as '192.168.1.2' and
netmask as '255.255.255.0'.
MiiNePort reports command executed successfully.
System sets auto report IP as '192.168.1.123', UDP port as '4000' and
report period as '50' sec.
MiiNePort reports command executed successfully.
System sets port 1's alias name as 'port 1'.
MiiNePort reports command executed successfully.
A-19