Moxa Technologies MiiNePort E2-H User Manual page 128

MiiNePort E2/E3
Real COM Allow Driver Control
Command code: RD
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: 1 (Enable) or 0 (Disable)
?RRD1;0
!RRD01
RFC2217 TCP alive check time
Command code: FA
Command parameters: Two numbers separated by a semicolon (;) denotes port index and MCSC channel index.
For MCSC-disabled port, channel index shall be 0.
Reply parameters: 1 (Enable) or 0 (Disable)
?RFA1;0↲
!RFA01↲
RFC2217 local listen port
Command code: FP
Command parameters: Two numbers separated by a semicolon (;) denotes port index and MCSC channel index.
For MCSC-disabled port, channel index shall be 0.
Reply parameters: local listen port
?RFP1;0↲
!RFP01234↲
TCP alive check time
Command code: TA
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: TCP alive check time.
?RTA1;0
!RTA05
TCP port
Command code: TP
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: TCP port.
?RTP1;0
!RTP04100
Introduction to SCM (Serial Command Mode) Command Set
System requests allow driver control policy for port1.
MiiNePort reports allow driver control as 'Enable'.
System requests for alive check time for port1.
MiiNePort reports alive check time is '1'.
System requests for RFC2217 local listen port for port 1.
MiiNePort reports RFC2217 local listen port is '1234'.
System requests TCP alive check time for port 1.
MiiNePort reports TCP alive check time as '5' minutes.
System requests TCP port for port 1.
MiiNePort reports TCP port as '4100'.
A-36